A small motherboard suitable for the N5105 chip with 4 2.5G network ports.

The overall vertical air duct design is adopted. You need to use the large heat sink in the package and bring your own 9015 fan (note that the fan blows upwards). The 2.5-inch hard disk with the thickest thickness of 15mm and the antenna installation position are reserved, which is convenient for use as a NAS or soft router.

The side panel adopts an easy-to-remove design. The whole process of replacing the hard disk can be completed by unscrewing four screws.

The overall dimensions are 160*140*100mm. 16 M3*8 countersunk screws are required for installation. The screw holes have reserved tolerances and sinks. No nuts and hot melt are required, but a certain printing accuracy is still required.

The design and sub-components fully consider the difficulty of printing. All parts do not need support. It is recommended to use frosted PEI board, which can easily print a better appearance.

Materials required for installing the shell:

If you need to install a 2.5 hard disk, you can choose a 20cm long side-bend sata cable and a ph2.0 to sata power cable